HP Netserver L Server series - Manual (Page 28)

Chapter 3 Installing Mass Storage Devices
22
Figure 3-5. Opening Drive Ejector Arms
2. Remove the drive:
a. Using both hands, grasp the ejector arms and firmly pull the drive out
about an inch to disengage the connection on the backplane.
See Figure 3-6.
b. Wait about 30 seconds for the drive to stop spinning and for the drive
heads to park.
c. Use your hand to support the bottom of the drive, while you slowly pull
the drive straight out. Do not allow the drive to fall.
3. Place the drive in an electrostatic protected container. Do not stack drives.