HP LaserJet P3005 Printer series - Manual (Page 40)

Item Values Explanation
MANUALLY FEED PROMPT: Determines when the device
shows a prompt regarding pulling from tray 1 if your print job
does not match the type or size that is loaded in any other tray.
● ALWAYS: Select this option if you always want to be
prompted before the device pulls from tray 1.
● UNLESS LOADED: Prompts you only if tray 1 is empty.
PS DEFER MEDIA: Controls whether the PostScript (PS) or
HP paper-handling model is used to print jobs. ENABLED
causes PS to defer to the HP paper-handling model.
DISABLED uses the PS paper-handling model.
SIZE/TYPE PROMPT: Use this menu item to control whether
the tray configuration message and its prompts are shown
whenever a tray is opened and closed. These prompts instruct
you to set the type or size if the tray is configured for a type or
size other than the type or size that is loaded in the tray.
SLEEP DELAY 1 MINUTE
15 MINUTES
30 MINUTES
45 MINUTES
60 MINUTES
90 MINUTES
2 HOURS
4 HOURS
Sets how long the device remains idle before it enters Sleep
mode.
Sleep mode does the following:
● Minimizes the amount of power that the device consumes
when it is idle.
● Reduces wear on electronic components in the device
(turns off the display backlight, but the display is still
readable).
The device automatically comes out of Sleep mode when you
send a print job, press a device control-panel button, open a
tray, or open the top cover.
The default setting is 30 MINUTES.
WAKE TIME MONDAY
TUESDAY
WEDNESDAY
THURSDAY
FRIDAY
SATURDAY
SUNDAY
Sets a “wake-up” time for the device to warm up and calibrate
each day. The default for each day is OFF. If you set a wake
time, HP recommends setting an extended sleep delay time
period, so that the device will not return to sleep mode soon
after waking.
PERSONALITY AUTO
PDF
PS
PCL
Selects the default device language (personality). The possible
values are determined by which valid languages are installed
in the device.
Normally, you should not change the device language. If you
change it to a specific device language, the device will not
switch automatically from one language to another unless
specific software commands are sent to the device.
The default setting is AUTO.
CLEARABLE WARNINGS JOB Sets the amount of time that a clearable warning appears on
the device control-panel display.
28 Chapter 2 Control panel ENWW