HP LaserJet P3005 Printer series - Manual (Page 134)

Control panel message Description Recommended action
For help press Press for help.
or
See Load media for more information.
MANUALLY FEED
alternates with
To continue press
Media is in tray 1, but the print job requires a
specific type and size that is not currently
available. Press to print from the tray.
or
Press for help.
or
See Load media for more information.
MANUALLY FEED
alternates with
To use another tray press
No media is in tray 1, and a print job requires
a specific type and size that is available in
another tray. Press to print from another tray. See Load
media for more information.
or
Press for help.
MANUALLY FEED OUTPUT STACK
alternates with
Then press to print second sides
The first side of a manual two-sided print job
has been printed and the device is paused
until for the output stack is reinserted. Take the printed stack out of the output bin
and reinsert it in tray 1 to print the second side
of the two-sided print job. Press
to
continue. See Print for more information.
MEM TEST FAILURE REPLACE DIMM 1 The memory DIMM has failed. Install a supported memory DIMM. See Install
memory .
NON HP SUPPLY IN USE
alternates with
Ready
The device has detected that a non-
HP supply is currently installed but
was
pressed to override the message.
If you believe you purchased an HP supply,
go to
www.hp.com/go/anticounterfeit .
Service or repairs that are required as a result
of using non-HP supplies are not covered
under HP warranty.
NON HP SUPPLY INSTALLED
alternates with
For help pressFor help press
A new, non-HP supply has been installed.
This message appears until an HP supply is
installed or you press
.
If you believe you purchased an HP supply,
go to
www.hp.com/go/anticounterfeit .
Service or repairs that are required as a result
of using non-HP supplies are not covered
under HP warranty.
To continue printing, press .
PAPER PATH JAM FRONT DOOR
alternates with
For help press
A page is jammed in the paper path. Open the front door and remove any jammed
media.
Paused
alternates with
To return to Ready press the STOP key
The device has paused. Press Stop to resume printing.
Performing upgrade A firmware upgrade is in process. No action necessary. Do not turn off the
device.
Performing... PAPER PATH TEST The device is performing a paper-path test. No action necessary.
122 Chapter 7 Problem solving ENWW