Enww control-panel messages 121 – HP LaserJet P3005 Printer series User Manual
Page 133
Control panel message
Description
Recommended action
Ready
Genuine HP supplies installed
A new HP cartridge has been installed. The
device returns to the Ready state after
approximately 10 seconds.
No action necessary.
Incorrect
The PIN number is incorrect.
Contact the network administrator.
INFLATE FAILURE
An error has occurred during a firmware
upgrade.
●
Reinstall the firmware.
●
If the problem persists, contact
HP Support.
Initializing
This message appears when the device is
turned on and begins initialization.
No action necessary.
Initializing permanent storage
This message appears when the device is
turned on to show that permanent storage is
being initialized.
No action necessary.
INSERT OR CLOSE TRAY XX
A tray is open and the device is trying to print
from another tray.
Close the tray indicated so that printing can
continue.
INSTALL FUSER
For help press
The fuser is either not installed or not
correctly installed in the device.
Press
for help.
or
Contact HP Customer Support or your
authorized HP service provider.
Install supply
alternates with
For status press
The print cartridge is missing.
Install the missing cartridge. For more
information, see
.
INSUFFICIENT MEMORY TO LOAD
FONTS/DATA
This message alternates with the name of the
storage device. The storage device does not
have enough memory to load the fonts or
other data.
Press
to continue printing without using
the data.
To solve the problem, increase the amount of
memory for the device. Press
for more
information.
LOAD TRAY X
alternates with
For help press
Tray X is either empty or configured for a type
and size other than that specified in the job.
No other tray is available.
Press
for help.
or
for more information.
LOAD TRAY X
alternates with
To use another tray press
Tray X is either empty or configured for a type
and size other than that specified in the job.
Press
for help.
or
Press
to print from another tray. See
for more information.
Loading program X
alternates with
DO NOT POWER OFF
Programs and fonts can be stored on the
device file system and are loaded into RAM
when the device is turned on. The number X
specifies a sequence number indicating the
current program being loaded.
No action necessary.
MANUALLY FEED
alternates with
Tray 1 is empty and no other tray is available. Load media into tray 1, and press
to
continue.
ENWW
Control-panel messages
121