HP Photosmart Premium Fax C309 - Manual (Page 134)

NOTE: Ink level warnings and indicators provide estimates for planning purposes only. When you receive
a low-ink warning message, consider having a replacement cartridge available to avoid possible printing
delays. You do not need to replace the cartridges until print quality becomes unacceptable.
For more information, see:
• Check the estimated ink levels
Cause: The ink cartridges might have insufficient ink.
If this did not solve the issue, try the next solution.
Solution 3: Contact HP support
Solution: Contact HP support for service.
Go to: www.hp.com/support .
If prompted, choose your country/region, and then click Contact HP for information on calling for technical
support.
Cause: There was a problem with the product.
Memory card troubleshooting
Use this section to solve these memory card problems:
• My memory card no longer works in my digital camera
• The product does not read the memory card
• The photos on the memory card do not transfer to my computer
• Photos in a connected digital camera with PictBridge do not print
My memory card no longer works in my digital camera
Solution: Reformat your memory card in your camera or format your memory card on a Windows computer
by selecting the FAT format. For more information, see the documentation that came with your digital camera.
Cause: You formatted the card on a Windows XP computer. By default, Windows XP formats a memory card
of 8 MB or less and 64 MB or more with the FAT32 format. Digital cameras and other products use the FAT
(FAT16 or FAT12) format and cannot recognize a FAT32 formatted card.
The product does not read the memory card
Try the following solutions to resolve the issue. Solutions are listed in order, with the most likely solution first. If the
first solution does not solve the problem, continue trying the remaining solutions until the issue is resolved.
• Solution 1: Insert the memory card properly
• Solution 2: Insert the memory card fully into the appropriate slot on the product
• Solution 3: Remove the additional memory card
• Solution 4: Reformat the memory card in your digital camera
Solution 1: Insert the memory card properly
Solution: Turn the memory card so that the label faces up and the contacts are facing the product, and then
push the card forward into the appropriate slot until the Photo light turns on.
If the memory card is not inserted properly, the product will not respond and the attention light will blink rapidly.
After the memory card has been inserted properly, the Photo light will blink green for a few seconds, and then
remain lit.
Chapter 13
132 Solve a problem
Solve a problem