Wrong, inaccurate, or bleeding colors – HP Photosmart Premium Fax C309 User Manual
Page 104
•
The printout has a horizontal band of distortion near the bottom of a borderless print
•
Printouts have horizontal streaks or lines
•
Printouts are faded or have dull colors
•
Printouts seem blurry or fuzzy
•
Printouts have vertical streaks
•
Printouts are slanted or skewed
•
Ink streaks on the back of the paper
•
Wrong, inaccurate, or bleeding colors
If your printout has one of the following print quality problems, try the solutions in this section for help.
•
Colors look different than what you expected.
For example, the colors in your graphic or photo look one way on your computer screen but print out differently,
or magenta was replaced with cyan in your printout.
•
Colors run into each other, or look like they are smeared on the page. The edges might have a feathering
appearance instead of being sharp and defined.
Try the following solutions if the colors appear wrong, inaccurate, or bleed into each other.
•
Solution 1: Make sure you are using genuine HP ink cartridges
•
Solution 2: Check the paper loaded in the input tray
•
Solution 3: Check the paper type
•
Solution 4: Check the ink levels
•
Solution 5: Check the print settings
•
•
Solution 7: Clean the printhead
•
Solution 8: Contact HP support
Solution 1: Make sure you are using genuine HP ink cartridges
Solution: Check to see if your ink cartridges are genuine HP ink cartridges.
HP recommends that you use genuine HP ink cartridges. Genuine HP ink cartridges are designed and tested
with HP printers to help you easily produce great results, time after time.
NOTE:
HP cannot guarantee the quality or reliability of non-HP supplies. Product service or repairs required
as a result of using a non-HP supply will not be covered under warranty.
If you believe you purchased genuine HP ink cartridges, go to:
Cause: Non-HP ink cartridges were being used.
If this did not solve the issue, try the next solution.
Solution 2: Check the paper loaded in the input tray
Solution: Make sure the paper is loaded correctly and that it is not wrinkled or too thick.
•
Load paper with the side you want to print on facing down. For example, if you are loading glossy photo
paper, load the paper with the glossy side down.
•
Make sure the paper lays flat in the input tray and is not wrinkled. If the paper is too close to the printhead
during printing, the ink might be smeared. This can happen if the paper is raised, wrinkled, or very thick,
such as a mailing envelope.
Chapter 13
102
Solve a problem
Solve a problem