beautypg.com

Cleaning ultrium tape drives – HP ESL E-series Tape Libraries User Manual

Page 86

background image

Use the cleaning tape more than once if a tape has severely contaminated the drive heads. If

the problem persists after two cleanings, and the cleaning tape has not expired, contact your

authorized service provider.

NOTE:

Do not use a DLT, DLT1, or VS cleaning tape (almond in color) in an SDLT drive. SDLT cleaning tapes

are gray and use a 7- or 8-character bar code label, CLNxxxS or CLNxxxS1.

To clean the tape heads:

1.

Move a cleaning cartridge into the drive using your application software. The tape drive

automatically loads the cartridge and cleans the heads.
During the cleaning cycle the drive’s green Ready LED flashes. At the end of the cleaning cycle,

the drive ejects the cartridge.

2.

Remove the cleaning cartridge from the drive.

Cleaning Ultrium tape drives

Be aware of the following:

Ultrium tape drives have been developed to have a minimal cleaning requirement.

An HP Ultrium Universal Cleaning Cartridge can be used up to 50 times. If you are using an

older HP Ultrium cleaning cartridge, check the documentation that came with your media.

CAUTION:

Only use HP Ultrium Universal Cleaning Cartridges in Ultrium tape drives.

If the cleaning cartridge is ejected immediately, then it has expired or is not an Ultrium cleaning

cartridge. Discard it and use a new one.

To clean the tape heads:

1.

Move a cleaning cartridge into the drive using your application software. The tape drive

automatically loads the cartridge and cleans the heads. The cleaning cycle can take up to five

minutes.

2.

Move the cleaning cartridge back to the proper storage bin using your application software.

86

Maintenance and troubleshooting