HP ESL E-series Tape Libraries User Manual
Page 116

Sense
key
ASC
ASCQ Message name / description
4
F3
02
DRIVE COMMUNICATION TIMEOUT
The library is unable to communicate with a drive.
•
Check the I2C cable, the cluster controller, and the cluster backplane
board.
•
Check that the drive is properly seated in the bay.
•
Swap the drive for a known-good drive and retry.
•
Reseat SCSI cabling and termination.
4
F3
20
DRIVE UNLOAD FAILED OR TIMED OUT
The command to the drive to unload the tape failed to complete or timed
out. Retry the unload command. If it fails again, manually attempt to
eject the tape.
4
F3
21
DRIVE EJECT FAILED OR TIMED OUT
The command to the drive to eject a tape failed to complete or time
out. Retry the unload command. If it fails again, manually attempt to
eject the tape.
4
F3
22
DRIVE LOAD FAILED OR TIMED OUT
The command to the drive to load a tape failed to complete or timed
out. Check drive logs for more information.
4
F3
23
DRIVE THREAD FAILED OR TIMED OUT
The command to the drive to thread a tape failed or timed out. Check
drive logs for more information.
5
04
07
DRIVE FW UPDATE IN PROGRESS
The drive can not perform indicated request because it is in the process
of updating it’s firmware. Wait until the firmware update is complete,
then retry the operation.
5
20
00
INVALID COMMAND OPERATION CODE
•
Verify the host command format.
•
Verify that the host software application is supported, has up-to-date
patches, and is correctly configured.
•
Verify that the library and its components have the current firmware.
5
21
01
INVALID ELEMENT ADDRESS
•
Check Mode Sense data for correct element addresses.
•
Verify that the host software application is supported, has up-to-date
patches, and is correctly configured.
•
Verify that the library and its components have the current firmware.
5
24
00
INVALID FIELD IN COMMAND DATA BLOCK
•
Ensure all reserve fields are set to zero.
•
Verify that the host software application is supported, has up-to-date
patches, and is correctly configured.
•
Verify that the library and its components have the current firmware.
5
25
00
LOGICAL UNIT IS NOT SUPPORTED
•
Verify the logical unit field specified in the command contains a
legitimate logical unit number.
•
Check cabling to logical unit.
•
Verify that the host software application is supported, has up-to-date
patches, and is correctly configured.
•
Verify that the library and its components have the current firmware.
116
Sense data values