HP ESL E-series Tape Libraries - Manual (Page 133)

Event ID Information event
0x609 FC Bridge Firmware upgrade, $ip, completed
0xa00 $panelname $name sensor status update, status $status
0xa02 CLM $name sensor status update, status $status
0xa03 The cabinet controller process was shut down
0xa04 Diagnostic command $cmd completed successfully for CLM
0xa05 Diagnostic command $cmd command failed for CLM
0xa06
Cabinet $framename state is $onlinestate with no user intervention
needed
0xa07 Cabinet $framename state is $onlinestate with homing of picker needed
0xa08 Cabinet $framename state is $onlinestate with user intervention needed
0xa09
System state is $onlinestate with $onlinestate with no user intervention
needed
0xa0a
System state is $onlinestate with $onlinestate with homing of picker
needed
0xa0b
System state is $onlinestate with $onlinestate with user intervention
needed
0xa0c
Partition $partname state is $onlinestate with no user intervention
needed
0xa0d Partition $partname state is $onlinestate with homing of picker needed
0xa0e Partition $partname state is $onlinestate with user intervention needed
0xa0f Test unit ready status for partition $partname changed to $tursense
0xa10 Drive reset initiated in cabinet $framename for drive $drive
0xa11 Drive reset failed in cabinet $framename for drive $drive
0xa12 CLM is communicating
0xa13 Lost communication with CLM
0xa14 CLM reboot initiated
0xa15 The cabinet controller process was started
HP StorageWorks 133