HP ESL E-series Tape Libraries - Manual (Page 64)

• When you are finished viewing/editing the setup information, press Back to return to the
Menu screen.
Viewing and editing the network settings (standalone libraries or primary cabinets only)
To view or edit the network settings:
1. From the Menu screen, use the Up and Down arrows to highlight Setup, then press Select.
2. The library prompts you for your password. Enter the 6-digit password and wait for validation.
The response may not be immediate.
NOTE:
The default password is 001122.
The Setup screen displays (see Figure 40 ).
Figure 40 Network Settings screen on standalone libraries or primary cabinets
3. Use the Up and Down buttons to select Change Network Settings and press Select.
The Setup screen displays the following information:
• IP Address
• IP Subnet Mask
• IP Gateway
• DHCP
• Save Network Settings Now
4. To edit the Network Settings information, use the Up and Down buttons to highlight the section
and press Select.
NOTE:
Setting the IP address requires one additional step. After pressing Select, power down
from the Menu screen.
Viewing the event log
In some cases, HP telephone support will ask you to view the events log in order to prepare your service
representative to assist you. To view the event log:
1. Press Menu from the Home screen.
2. Use the Down button to highlight EVENT LOG, then press Select.
3. Scroll through the events listed in the log (see Figure 41 ) using the Down button.
64 Library operations