HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 331)

The following shows examples of editing the /etc/lvm/lvm.conf file.
Figure 4-6 Example of Editing /etc/lvm/lvm.conf file
Comment out the existing filter and types lines, and add the shaded
lines in the figure.
Set 0 in md_component_detection.
Record the original md_component_detection value, because it is
necessary for removal or upgrade installation of HDLM.
28
.
Edit the /etc/fstab file.
Change the /boot mount point that you changed in step 5 from the SCSI
device to the HDLM device. Mark the existing SCSI device specification as
a comment by entering a hash mark (#) at the beginning of each line, and
then add the HDLM device specification as follows:
:
:
#/dev/sda1 /boot ext3 defaults 1 2
/dev/sddlmaa1 /boot ext3 defaults 1 2
:
:
This example assumes that IA32 uses GRUB as the boot loader. When you
use IPF that uses ELILO as the boot loader, the mount point is displayed
as /boot/efi instead of /boot in the line where /boot is coded, and the
file system type is displayed as vfat instead of ext3.
29
.
Specify the settings so that the HDLM device is not configured when the
host starts.
Change hdlm_dracut=n defined in the /etc/opt/DynamicLinkManager/
hdlm.conf file to hdlm_dracut=y.
30
.
Create an initial RAM disk image file for HDLM.
From the following, perform the procedure that corresponds to the host
OS.
HDLM Operation
4-27
Hitachi Dynamic Link Manager (for Linux®) User Guide