HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 229)

• Startup from a SCSI device was selected in the boot loader configuration,
but /etc/fstab file was defined to mount an HDLM device.
To correct the above error:
1
.
Enter the root user password.
2
.
Execute mount -o remount rw / to mount the root directory again.
3
.
In the /etc/fstab file, change the mount destination of root to the SCSI
device.
4
.
Restart the host to start the OS from the SCSI device.
5
.
To restart the OS from an HDLM device, set up the environment according
to the following procedure:
Follow the procedure in
Settings for a Multipath Boot Disk Environment on
page 3-142 or Upgrade installation of HDLM in a Boot Disk Environment
on page 3-151 .
Settings for LUKS
This section explains the procedures that the user must perform when using
LUKS.
Notes on Using LUKS
The followings are notes on using LUKS:
• HDLM supports LUKS on the following OSs:
¢
Red Hat Enterprise Linux 5.3
¢
Red Hat Enterprise Linux 5.3 Advanced Platform.
¢
Red Hat Enterprise Linux 5.4
¢
Red Hat Enterprise Linux 5.4 Advanced Platform.
¢
Red Hat Enterprise Linux 5.5
¢
Red Hat Enterprise Linux 5.5 Advanced Platform.
¢
Red Hat Enterprise Linux 5.6
¢
Red Hat Enterprise Linux 5.6 Advanced Platform.
¢
Red Hat Enterprise Linux 5.7
¢
Red Hat Enterprise Linux 5.7 Advanced Platform.
¢
Red Hat Enterprise Linux 5.8
¢
Red Hat Enterprise Linux 5.8 Advanced Platform.
¢
Red Hat Enterprise Linux 5.9
¢
Red Hat Enterprise Linux 5.9 Advanced Platform.
¢
Red Hat Enterprise Linux 6
• LUKS is not available in an environment where an HDLM device is used as
a boot disk.
Creating an HDLM Environment
3-157
Hitachi Dynamic Link Manager (for Linux®) User Guide