HP McDATA 4Gb SAN Switch for HP BladeSystem p-Class - Manual (Page 178)

178 Command Line Interface
Show command
Description Displays fabric, switch, and port operational information.
Authority None
Syntax
show
about
alarm [option]
audit
broadcast
chassis
cimlistener [listener_name]
cimsubscription [subscription_name]
config [option]
domains
fabric
fdmi [port_wwn]
interface
log [option]
lsdb
mem [count]
ns [option]
pagebreak
perf [option]
port [port_number]
post log
setup [option]
steering [domain_id]
support
switch
timezone
topology
users
version
Operands
about
Displays an introductory set of information about operational attributes of the switch. This
operand is equivalent to the Version operand.
alarm [option]
Displays the alarm log and session display setting. If you omit [option], the command displays
the last 200 alarm entries. The alarm log is cleared when the switch is reset or power cycled.
[option] has the following value:
setting
Displays the status of the parameter that controls the display of alarms in the session output
stream. This parameter is set using the Set Alarm command.
audit
Displays the most recent 200 records in the administrative audit log. The audit log contains
configuration and administrative changes that have been made to the switch including the
originating management session and IP address.
broadcast
Displays the broadcast tree information and all ports that are currently transmitting and receiving
broadcast frames.
chassis
Displays chassis component status and temperature.