HP McDATA 4Gb SAN Switch for HP BladeSystem p-Class User Manual
Page 174
174 Command Line Interface
system
Prompts you in a line-by-line fashion to change system configuration settings.
describes
the system configuration fields. For each parameter, enter a new value or press Enter to accept
the current value shown in brackets.
NOTE:
Changing the IP address will terminate all Ethernet management sessions.
Table 52
System configuration settings
Entry
Description
Eth0NetworkDiscovery Ethernet boot method: 1 - Static, 2 - Bootp, 3 - DHCP, 4 - RARP. The default
is 1 - Static.
Eth0NetworkAddress
Ethernet Internet Protocol (IP) address. The default is 10.0.0.1.
Eth0NetworkMask
Ethernet subnet mask address. The default is 255.0.0.0.
Eth0GatewayAddress
Ethernet IP address gateway. The default is 10.0.0.254.
AdminTimeout
Amount of time in minutes the switch waits before terminating an idle
Admin session. Zero (0) disables the time out threshold. The default is 30,
the maximum is 1440.
InactivityTimeout
Amount of time in minutes the switch waits before terminating an idle
Telnet CLI session. Zero (0) disables the time out threshold. The default is 0,
the maximum is 1440.
LocalLogEnabled
Enables (True) or disables (False) the saving of log information on the
switch. The default is True.
RemoteLogEnabled
Enables (True) or disables (False) the recording of the switch event log on a
remote host that supports the syslog protocol. The default is False.
RemoteLogHostAddress The IP address of the host that will receive the switch event log information
if remote logging is enabled. The default is 10.0.0.254.
NTPClientEnabled
Enables (True) or disables (False) the Network Time Protocol (NTP) client
on the switch. This client enables the switch to synchronize its time with an
NTP server. This feature supports NTP version 4 and is compatible with
version 3. An Ethernet connection to the server is required and you must
first set an initial time and date on the switch. The synchronized time
becomes effective immediately. The default is False.
NTPServerAddress
The IP address of the NTP server from which the NTP client acquires the
time and date. The default is 10.0.0.254.
EmbeddedGUIEnabled Enables (True) or disables (False) the McDATA Web Server. Changing this
parameter to False while the applet is running will terminate the applet.
The default is True.