HP NonStop G-Series - Manual (Page 156)

The 5157/5157 ACL S-Series Subsystems Installation/Users Guide
Appendix A
iii
Table A-1 Error Recovery Procedures
ERP
Number
Procedure Detail
C Cycle power to the drive using the AC switch on
the front panel of the module. Wait 30 seconds to
power on again.
D Turn off power to the module and inspect
connectors and cables.
F Invalid operation. Select parameters correctly and
try again
G Call Technical Support.
A.1.3.2 Fault Symptom Codes (FSC)
Fault Symptom Codes appear in the Fault Screen described
in Section A.1 of the Appendix. Each FSC is accompanied
by a descriptive message and instructions for clearing the
fault. If a fault persists, look up the FSC in Table A-1 and
call the Technical Support Representative. Be sure to
furnish the FSC to help identify the problem.