HP NonStop G-Series User Manual
Page 135
5157/5157 ACL S-Series DLT Subsystems Installation/Users Guide
Installing and Configuring the 5157/5157 ACL Digital Linear Tape Subsystem
for S-Series Servers
7-10
Group and slot labels help to locate CRUs that need service. Some
software might show the location of a CRU using abbreviations for
group, module, and slot. For example the Subsystem Control
Facility (SCF) storage subsystem might display the location of a
PMF CRU as:
PMF.GRP-1.MOD-1.SLOT-50
For more information on system organization, group numbering, or
labeling in a Himalaya S-Series server, refer to the Himalaya S-
Series Planning and Configuration Guide.
7.3.2.3 Completing the PMF CRU Configuration Form
If a tape drive CRU is to be connected to a PMF CRU, document
the configuration of the PMF CRU using a PMF CRU
Configuration Form. This form documents configurable entities
associated with the connectors on a PMF CRU. It also provides
information about the tape drive to be connected to the PMF CRU.
Note: The SCSI passthrough terminator is preinstalled on the
differential SCSI port.
Figure 7-4 shows an example of a completed PMF CRU
Configuration Form. For a blank PMF CRU Configuration, refer
to the Himalaya S-Series Planning and Configuration Guide.
The SCSI Port information block must completed on the form if a
tape drive is to be attached to a PMF CRU:
•
Enter the product number of the tape drive in the Product
Number field. The correct product number is 5157.
•
Enter the Subsystem Control Facility (SCF) name of the tape
drive in the SCF Name field.