HP NonStop G-Series - Manual (Page 112)

5157/5157 ACL S-Series DLT Subsystems Installation Users Guide
Operating the 5157 ACL Tape Drive 6-23
Note: The control panel lock also prevents operator access to the
Unlock Door selection on the Main Menu. For a detailed discussion
of magazine locking, see the sections titled “Removing the
Magazine” and “Inserting a Magazine into the 5157 ACL” later in
this chapter.
Even while the control panel is locked, the Status Menu can still be
displayed without using the security code by pressing the Escape
button at the Default Screen.
When the Enter button is pressed, the screen in Figure 6-19
appears.
Unlock Code
Unlock Code й й
“ “ “ “
к к
Figure 6-19 Code Entry Submenu
Using the ù button and the ü button, set the first digit of the
unlock code. Press the Enter button to move the cursor to the
second digit and repeat the process. When the entire unlock code
has been entered using this process, press the Escape button. Press
the Enter button to validate the unlock code or the Escape button
to exit. If the code is correct, the Main Menu is displayed. If the
code is incorrect, an error screen appears.
6.12 Displaying Firmware Revision
The library robotics firmware revision may be displayed at any time.
It appears as one of the items on the Library Status submenu of the
Show Status Menu. It is also displayed on line 2 of the POST
Screen and the Initialization Screens.