HP NonStop G-Series - Manual (Page 120)

5157/5157 ACL S-Series DLT Subsystems Installation Users Guide
Operating the 5157 ACL Tape Drive 6-31
6.22 Loading and Unloading Tapes
The Load/Unload menu enables the operator to specify a source
and a destination for a cartridge movement. As a result, the
procedure to load is the same for unloading. To load or unload a
tape from the front panel of the module, use the Load/Unload
menus as follows:
DLT1 Idle DLT1 Idle
Loader Idle Loader Idle
1 1 A Ayy------------- -------------я я10 10
Figure 6-24 Default Screen
A default screen is shown in Figure 6-24. Note that DLT1 has a
tape loaded. When this screen indicates DLT1 Idle, it means that
the drive has a cartridge loaded and is awaiting instructions. Note
also that slot 1 of the magazine has a cartridge present, while the
remaining slots are empty.
From the Default Screen, enter the Menu Mode by pressing the
Enter button. The Main Menu shown in Figure 6-25 appears.
Note: If the control panel has been locked, the screen shown in
Figure 6-9 appears. If the unlock code is unknown, contact the
system administrator.
÷ ÷Load/Unload Load/Unload
Unlock Door Unlock Door
Show Status Menu Show Status Menu
Maintenance Menu Maintenance Menu к к
Figure 6-25 Main Menu