HP Storage Mirroring V5.1 Software - Manual (Page 167)

19 - 31
Running DTStat from the command prompt
From a command prompt, use the DTStat command from the location where Storage Mirroring is
installed.
Command DTSTAT
Description Starts the DTStats statistics logging utility from a command prompt
Syntax DTSTAT [-p][-i < interval >][-t < filename >] [-f < filename >]
[-s < filename >] [-st < filename >][-IP < address >]
[-START < mm/dd/yyyy hh:mm >][-STOP < mm/dd/yyyy hh:mm >]
[-SERVER < ip_address > < port_number >]
Options

-p—Do not print the output to the screen

-i interval —Refresh from shared memory every interval seconds. If the
interval is set to zero (0), then the utility will run once and stop.

-t filename —Save the data from memory to the specified binary file
filename

-f filename —Reads from a previously saved binary file, filename, that was
generated using the -t option instead of reading from memory

-s filename —Saves only the connection data from the data in memory to an
ASCII, comma-delimited file, filename

-st filename —Saves only the target data from the data in memory to an
ASCII, comma-delimited file, filename

-f filename1 -s filename2 —Saves only the connection data from a
previously saved binary file, filename1, to an ASCII, comma-delimited file,
filename2

-f filename1 -st filename2 —Saves only the target data from a previously
saved binary file, filename1, to an ASCII, comma-delimited file, filename2

-IP address —Filters out the specified address in the IP address field and
prints only those entries. Specify more than one IP address by separating
them by a comma.

-START mm/dd/yyyy hh:mm —Filters out any data prior to the specified
date and time

-STOP mm/dd/yyyy hh:mm —Filters out any data after the specified date
and time

-SERVER ip_address port_number —Connects DTStat to the specified IP
address using the specified port number instead of to the local machine
Examples

DTStat -i 300

DTStat -p -i 300 -t AlphaStats.sts

DTStat -f AlphaStats.sts -s AlphaStats.csv -start
02/02/2008 09:25

DTStat -server 206.31.4.51 1106
Notes

This command is not case-sensitive.

If no options are specified, DTStat will print the output to the screen at an
interval of every one second.

If the statistics are not changing, DTStat will discontinue writing until
statistics begin updating again.