HP Storage Mirroring V5.1 Software User Manual

Page 135

18 - 6

Now you can begin your restoration process.

From the Management Console on the target, select Tools, Restoration Manager.

Identify the Original Source machine. This is your source machine where the data originally

resided.

Select the Restore From machine. This is the target machine where the copy of the data is

stored.

Replication Set

contains the replication set information stored on the target machine (the

machine in Restore From). If no replication sets are available, the list will be blank. Select

the replication set that corresponds to the data that you need to restore.

Select the Restore To machine. This is your source where the updated data from the target

will be sent.

The Restore To

and Restore From paths will automatically be populated when the

replication set is selected. The restore to path is the directory that is the common parent

directory for all of the directories in the replication set. If the replication set crosses

volumes, then there will be a separate path for each volume. The restore from path is the

path on the target server where the replicated files are located.

Select the Use Backup Replication Set check box to use the target’s copy of the replication

set database for the restoration. If this check box is not marked, you will be accessing the

replication set information from the source.

Select the Restore Replication Set check box to restore the target’s copy of the replication

set database to the source during the restoration process.

Select the restoration conditionals that you want to use.



Overwrite existing files during restore

—

This option restores all existing files by

overwriting them. Any files that do not exist on the source are written also. If this option

is disabled, only files that do not exist on the source will be restored.

NOTE:

Restoring across a NAT router requires the ports to be the same as the original

connection. If the ports have been modified (manually or reinstalled), you must

set the port numbers to the same values as the last valid source/target

connection.

This manual is related to the following products: