HP Storage Mirroring V5.1 Software - Manual (Page 152)

19 - 16
4067 Service Error No replication ops have been
received from the driver for an
extended period of time.
Check other messages for errors
with the Storage Mirroring
drivers, and correct as required.
If there are no driver messages,
verify that your drives are
connected to the source. If this
error persists, contact technical
support.
4068 Service Error Failed to write to a replicating
volume.
Reboot the source server.
Contact technical support if this
event occurs again.
4096 System Warning The registry parameter %2 is
unknown.
Delete the parameter and report
this issue to technical support.
4097 System Warning Failed to initialize WMI support.
The last Word in the Data
Window is the NT status code.
No action required.
4097 System Error The file system filter failed to
load. Replication will not occur.
Reboot your server and contact
technical support if this error
occurs again. The last Word in
the Data window is the NT status
code.
Reboot your server and contact
technical support if this event
occurs again.
4098 System Warning The registry parameters failed
to load, so the default
configuration values will be
used. The last Word in the Data
window is the NT status code.
No action required.
4098 System Error The control device %2 was not
created. Communication with
the service will be disabled.
Reboot the server and contact
technical support if this error
occurs again. The last Word in
the Data window is the NT status
code.
Reboot your server and contact
technical support if this event
occurs again.
4099 System Warning The driver detected a hard link
for a file on drive %2. Hard links
are not supported. Changes to
this file will not be replicated.
Hard links are not supported.
4099 System Error The driver failed to register with
filter manager. Reboot the
server and contact technical
support if this error occurs
again. The last Word in the Data
window is the NT status code.
Reboot your server and contact
technical support if this event
occurs again.
4100 Activation Key Error Product activation code is
invalid. Please check that it is
typed correctly and is valid for
the version of the operating
system in use.
If you are in the process of
installing Storage Mirroring,
verify that you are using a 16
character alpha-numeric code.
If Storage Mirroring is already
installed, confirm that the code
entered is correct. If the code
appears to be correct, contact
technical support.
ID Category Severity Event Message Required Response