HP Storage Mirroring V5 Software - Manual (Page 74)

6 - 13
Options ‹ repset —Name of the replication set
‹ target_machine —Name of the target machine, an IP address on the target machine, or a virtual IP
address
‹ MAP EXACT —Specifies that the replication set data will be sent to the same logical volume on the
target
‹ MAP BASE —The replication set data will be sent to the locations specified below:
‹ connect repset to target —If mappings are not specified with the command, map base
will be used by default. The data will be replicated to /SrcName/RepsetName/SrcVolName
on the target machine
‹ connect repset to target map base target_path —Substitute a complete path, including
the volume, for target_path and the data will be replicated to /target_path/SrcVolName on
the target machine
‹ connect repset to target map base source_path TO target_path —Custom location
that specifies each directory on the source and where that data will be copied to on the target
machine
‹ ... —Indicates that the s ource_path TO target_path option can be used more than once for each
source directory in the replication set
‹ MIRROR —Automatically initiates a mirror when the connection is established
‹ NOMIRROR —Does not initiate a mirror when the connection is established
‹ REPLICATE —Automatically initiates replication when the connection is established
‹ NOREPLICATE —Does not initiate replication when the connection is established
‹ MONITOR —Specifies that the target is going to monitor the specified source machine for failover.
The source machine must have already been defined as a monitor machine.
‹ NOMONITOR —Specifies that the target is not going to monitor the source machine for failover
‹ ORPHANS —Removes orphan files on the target
‹ NOORPHANS —Does not remove orphan files on the target
Examples ‹ connect “Customer Data” to jersey map exact
‹ connect marketing to jersey map base /home/username
Notes ‹ The default settings for this command are mirror, replicate, nomonitor, and noorphans.
‹ Options that contain non-alphanumeric characters must be enclosed in quotation marks.
‹ If you are establishing a connection within a NAT environment, you will need to specify the port
of the router after the IP address (separated by a colon).