HP Storage Mirroring V5 Software - Manual (Page 184)

13 - 16
NSIPHDriver 9004 Error Could not allocate buffer to hold initial
IP address list for adapter Reboot the server and contact
technical support if this event occurs
again.
9005 Error Could not allocate buffer to hold initial
subnet mask list for adapter Reboot the server and contact
technical support if this event occurs
again.
9006 Error Could not read registry value for IP
address list or subnet mask list for
adapter Reboot the server and contact
technical support if this event occurs
again.
9007 Error Could not write registry value for IP
address list for adapter Reboot the server and contact
technical support if this event occurs
again.
9008 Error Could not write registry value for
subnet mask list for adapter Reboot the server and contact
technical support if this event occurs
again.
9009 Error Could not form full registry path to
adapter Reboot the server and contact
technical support if this event occurs
again.
Recognizer 12288 Error Nsi-recognizer was started improperly.
Nsi-recognizer must be started during
boot. Change Nsi-recognizer's Startup
value to Boot in the Devices applet of
Control Panel, then reboot the system. In the Control Panel Devices applet,
change NSI-recognizer Startup value to
Boot. Reboot the server for the
change to take effect.
Resources 8192 Warning Kernel memory was exhausted.
Replication is stopped. Contact technical support if this event
occurs again.
8192 Error Failed to create device list entry due to
insufficient resources. Contact technical support if this event
occurs again.
8193 Error Failed to create Transfer Thread. The
last Word in the Data Window is the
NT status code. Reboot the server and contact
technical support if this event occurs
again.
8194 Error Failed to create filename work queue.
The last Word in the Data Window is
the NT status code. Reboot the server and contact
technical support if this event occurs
again.
8195 Error Failed to create file close queue. The
last Word in the Data Window is the
NT status code. Reboot the server and contact
technical support if this event occurs
again.
8196 Warning The maximum amount of memory for
replication queuing has been reached.
Replication is stopped and memory is
being freed. Contact technical support if this event
occurs again.
8197 Error Failed to create file delete queue. The
last Word in the Data Window is the
NT status code. Reboot the server and contact
technical support if this event occurs
again.
8198 Error Failed to save the registry path. The
last Word in the Data Window is the
NT status code. Reboot the server and contact
technical support if this event occurs
again.
8199 Error Failed to create tracked file queue.
The last Word in the Data Window is
the NT status code. Reboot the server and contact
technical support if this event occurs
again.
Category ID Severity Message Required Response