HP Storage Mirroring V5 Software - Manual (Page 185)

13 - 17
Resources 8200 Warning Failed to allocate buffer for querying
very long filenames, i.e., names over
260 characters. Replication will
continue for standard length filenames.
The last Word in the Data Window is
the NT status code. Reboot the server and contact
technical support if this event occurs
again.
8201 Warning Reached stop replicating page limit.
Replication is stopped. Configure the applications on the
server to use less memory or add
more memory so that the server does
not get into a low memory state.
8201 Warning Reached stop replicating page limit.
Replication is stopped. Configure the applications on the
server to use less memory or add
more memory so that the server does
not get into a low memory state.
8202 Error Failed to create Tracked File System
worker thread. The last Word in the
Data Window is the NT status code. The Storage Mirroring driver cannot
create the thread used by the tracked
file system. If a thread cannot be
created, the system is low on critical
resources. Reboot the server and
contact technical support if this event
occurs again.
Service 4000 Info Kernel was successfully started. No action required.
4001 Info Target service was successfully started. No action required.
4002 Info Source service was successfully
started. No action required.
4003 Info Source service was successfully
stopped. No action required.
4004 Info Target service was successfully
stopped. No action required.
4005 Info Kernel was successfully stopped. No action required.
4006 Error Service has aborted due to the
following unrecoverable error: %1 Restart the Storage Mirroring service.
4007 Warning Auto-disconnecting connection ID: %1 Auto-disconnect occurs when the
queue has been filled or if there is a
problem using the queue. Contact
technical support if this event occurs
frequently.
4008 Success Auto-disconnect has succeeded on
connection ID: %1 No action required.
4009 Info Auto-reconnecting Replication Set %1
to %2 No action required.
4010 Success Auto-reconnect has succeeded
connecting Replication Set %1 to %2 No action required.
4011 Error Auto-reconnect has failed connecting
Replication %1 to %2 Manually reestablish the replication set
to target connection.
4014 Info Service has started network
transmission. No action required.
4015 Info Service has stopped network
transmission. No action required.
4016 Info Service has established a connection to
%1 for Replication Set %2, ID: %3 No action required.
Category ID Severity Message Required Response