Managing verification with the management console, Configuring verification on connection, Configuring verification on connection -5 – HP Storage Mirroring V5 Software User Manual
Page 112
9
-
5
Managing Verification With the Management Console
In the Management Console, verification can be configured when a connection is established or it can be initiated manually at
any time while a connection is active.
Configuring verification on connection
1.
There are four methods available for establishing a connection and opening the Connection Manager:
Highlight a replication set and select
Tools
,
Connection Manager
.
Right-click on a replication set and select
Connection Manager
.
Drag and drop a replication set to a target machine on the left pane of the Management Console.
Highlight a replication set and then drag and drop the replication set to a target machine on the right pane of the
Management Console.
The Connection Manager will open and the Servers tab will be selected. Complete the Servers tab entries as described
in .
2.
Select the
Verify
tab.
3.
Select the verification options that you would like to perform.
The
Initial Verification Start
field allows you to select the immediate date and time by clicking
Now
or entering in
a specific
Date
and
Time
. The down arrow next to
Date
displays a calendar allowing easy selection of any date.
Time
is formatted for any AM or PM time.
Mark the
Reverification Interval
check box to repeat the verification process at the specified interval. Specify an
amount of time and choose minutes, hours, or days.
Mark the
Remirror files to the Target automatically
,
Only if Source file is newer than Target copy
, and/or
Use
block checksum comparison/delta block transfer
check boxes to perform the type of remirror you desire. To
determine the options to select for the type of remirror you wish to perform, see the chart .
NOTE:
The settings on the Verify tab are dependent on some of the settings on the Server tab. If any of the top four
Server settings (
Source Server
,
Replication Set
,
Target Server
,
Route
) are modified after verification settings
are established, the verification settings will be cleared and will need to be reset.