HP Storage Mirroring V5 Software - Manual (Page 166)

12 - 8
4. Restore Storage Mirroring data from target to the source by using the restore from command.
Command RESTORE
Description Initiates the restoration process
Syntax RESTORE < repset > FROM < target_machine > [ORIGINAL < original_source_machine > ]
[, OVERWRITE | NOOVERWRITE][, OVERWRITENEWER | NOOVERWRITENEWER]
[, USETARGETDB | NOUSETARGETDB][, RESTOREDBTOO | NORESTOREDBTOO]
[, CHECKSUM][, ORPHANS | NOORPHANS]
Options ‹ repset —Name of the replication set
‹ target_machine —Name of the target machine
‹ original_source_machine —Specifies that the replication set was not originated on the current
source machine
‹ OVERWRITE —Overwrites files on the source
‹ NOOVERWRITE —Does not overwrite files on the source
‹ OVERWRITENEWER —Overwrites files on the source even if the source file is newer than on the
target
‹ NOOVERWRITENEWER —Does not overwrite files on the source that are newer on the source than
on the target
‹ USETARGETDB —Uses the replication set from the target machine
‹ NOUSETARGETDB —Uses the replication set from the source machine
‹ RESTOREDBTOO —Restores the replication set from the target to the source
‹ NORESTOREDBTOO —Does not restore the replication set from the target to the source
‹ CHECKSUM —Performs a block checksum comparison and only restores those blocks that are
different
‹ ORPHANS —Removes orphan files on the target
‹ NOORPHANS —Does not remove orphan files on the target
Examples restore “Customer Data” from jersey, overwritenewer, usetargetdb
Notes ‹ The default settings for this command are overwrite, overwritenewer, usetargetdb, restoredbtoo,
and noorphans.
‹ The source command is required before each use of the restore command.
‹ Options that contain non-alphanumeric characters must be enclosed in quotation marks.
‹ If you are using the restore command with the DTCL interactive or batch client ( dtcl -i or
dtcl -f ), the command requires the original source option. This option is not required if you
are using the Text Client.