HP NonStop G-Series - Manual (Page 311)

COUP and PUP Interfaces
HP NonStop Storage Management Foundation User's Guide—523562-008
B-7
DSC/COUP Commands
DSC/COUP Commands
Table B-1 summarizes the COUP commands you use to configure and manage
$ZSMS, storage pool processes, and virtual disk processes. For additional information
on specific prerequisites of certain command operations, see
COUP and PUP
Prerequisite Summary on page B-52.
Following a discussion of the PROCESS attribute set, each command summarized in
Table B-1 is described in detail. Refer to the Dynamic System Configuration (DSC)
Manual for complete information about using the DSC utility and its COUP interface.
PROCESS Attribute Set
The PROCESS attribute set is a collection of attributes that describe an SMF process.
You specify these attributes as parameters in the following commands: SET, ADD, and
ALTER. The parameters listed constitute the subset of COUP PROCESS attribute
parameters that have an effect on SMF processes. COUP supports somewhat different
Table B-1. COUP Command Summary
COUP Command Description
ADD Adds an entry for a process to the OSCONFIG file; optionally
assigns process attributes.
ALTER Changes the attributes in an existing OSCONFIG entry for a
process.
ASSUME Sets the default object type to PROCESS so it need not be specified
in subsequently submitted COUP commands.
DELETE Deletes the OSCONFIG entry for a process that is not running.
INFO Retrieves information about attributes associated with an
OSCONFIG entry for a process; optionally retrieves additional
information about the process if it is currently running.
SET Defines attributes for a process that does not yet have an
OSCONFIG entry.
START Starts the execution of a process.
STATUS Retrieves information about currently executing processes.
STOP Stops the execution of a process.