Accton Technology VS4512DC - Manual (Page 191)

System Management Commands
4-45
Command Usage
• The time acquired from time servers is used to record accurate dates and times
for log events. Without SNTP, the switch only records the time starting from the
factory default set at the last bootup
(e.g., 00:00:00, Jan. 1, 2001).
• This command enables client time requests to time servers specified via the
sntp servers command. It issues time synchronization requests based on the
interval set via the sntp poll command.
• The SNTP time query method is set to client mode when the first sntp client
command is issued. However, if the sntp broadcast client command is issued,
then the no sntp broadcast client command must be used to return the switch
to SNTP client mode.
Example
Related Commands
sntp server (4-45)
sntp poll (4-46)
sntp broadcast client (4-47)
show sntp (4-47)
sntp server
This command sets the IP address of the servers to which SNTP time requests are
issued. Use the this command with no arguments to clear all time servers from the
current list.
Syntax
sntp server [ip1 [ip2 [ip3]]]
ip - IP address of an time server (NTP or SNTP).
(Range: 1 - 3 addresses)
Default Setting
None
Command Mode
Global Configuration
Console(config)#sntp server 10.1.0.19
Console(config)#sntp poll 60
Console(config)#sntp client
Console(config)#end
Console#show sntp
Current time: Dec 23 02:52:44 2002
Poll interval: 60
Current mode: unicast
Console#