Accton Technology VS4512DC - Manual (Page 268)

Command Line Interface
4-122
Address Table Commands
These commands are used to configure the address table for filtering specified
addresses, displaying current entries, clearing the table, or setting the aging time.
mac-address-table static
This command maps a static address to a destination port in a VLAN. Use the no
form to remove an address.
Syntax
mac-address-table static mac-address interface interface vlan vlan-id [action]
no mac-address-table static mac-address vlan vlan-id
• mac-address - MAC address.
• interface
• ethernet unit/port
- unit - This is device 1
- port - Port number
• port-channel channel-id (Value: 1)
• vlan-id - VLAN ID (Range: 1-4093)
• action
- delete-on-reset - Assignment lasts until the switch is reset.
- permanent - Assignment is permanent.
Default Setting
No static addresses are defined. The default mode is permanent.
Command Mode
Global Configuration
Command Usage
The static address for a host device can be assigned to a specific port within
a specific VLAN. Use this command to add static addresses to the MAC
Address Table. Static addresses have the following characteristics:
• Static addresses will not be removed from the address table when a given
interface link is down.
Command Function Mode Page
mac-address-table static Maps a static address to a port in a VLAN GC 4-122
clear mac-address-table
dynamic
Removes any learned entries from the forwarding database PE 4-123
show mac-address-table Displays entries in the bridge-forwarding database PE 4-123
mac-address-table
aging-time
Sets the aging time of the address table GC 4-124
show mac-address-table
aging-time
Shows the aging time for the address table PE 4-125