Accton Technology VS4512DC - Manual (Page 192)

Command Line Interface
4-46
Command Usage
This command specifies time servers from which the switch will poll for time
updates when set to SNTP client mode. The client will poll the time servers in
the order specified until a response is received. It issues time synchronization
requests based on the interval set via the sntp poll command.
Example
Related Commands
sntp client (4-44)
sntp poll (4-46)
show sntp (4-47)
sntp poll
This command sets the interval between sending time requests when the switch is
set to SNTP client mode. Use the no form to restore to the default.
Syntax
sntp poll seconds
no sntp poll
seconds - Interval between time requests. (Range: 16-16384 seconds)
Default Setting
16 seconds
Command Mode
Global Configuration
Command Usage
This command is only applicable when the switch is set to SNTP client mode.
Example
Related Commands
sntp client (4-44)
Console(config)#sntp server 10.1.0.19
Console#
Console(config)#sntp poll 60
Console#