Accton Technology VS4512DC - Manual (Page 205)

Flash/File Commands
4-59
whichboot
This command displays which files were booted when the system powered up.
Default Setting
None
Command Mode
Privileged Exec
Example
This example shows the information displayed by the whichboot command. See
the table under the dir command for a description of the file information displayed by
this command.
boot system
This command specifies the image used to start up the system.
Syntax
boot system {boot-rom| config | opcode}: filename
The type of file or image to set as a default includes:
• boot-rom - Boot ROM.
• config - Configuration file.
• opcode - Run-time operation code.
The colon (:) is required.
filename - Name of the configuration file or image name.
Default Setting
None
Command Mode
Global Configuration
• Command Usage
• A colon (:) is required after the specified file type.
• If the file contains an error, it cannot be set as the default file.
Example
Console#whichboot
file name file type startup size (byte)
----------------- -------------- ------- -----------
diag_0060 Boot-Rom image Y 111360
run_0200 Operation Code Y 1083008
startup Config File Y 2710
Console#
Console(config)#boot system config: startup
Console(config)#