Accton Technology VS4512DC - Manual (Page 162)

Command Line Interface
4-16
stopbits
This command sets the number of the stop bits transmitted per byte. Use the no
form to restore the default setting.
Syntax
stopbits {1 | 2}
• 1 - One stop bit
• 2 - Two stop bits
Default Setting
1 stop bit
Command Mode
Line Configuration
Example
To specify 2 stop bits, enter this command:
disconnect
Use this command to terminate an SSH, Telnet, or console connection.
Syntax
disconnect session-id
session-id – The session identifier for an SSH, Telnet or console
connection. (Range: 0-4)
Command Mode
Privileged Exec
Command Usage
Specifying session identifier “0” will disconnect the console connection.
Specifying any other identifiers for an active session will disconnect an SSH or
Telnet connection.
Example
Related Commands
Event Logging Commands (4-35)
show users (4-53)
Console(config-line)#stopbits 2
Console(config-line)#
Console#disconnect 1
Console#