Accton Technology VS4512DC - Manual (Page 240)

Command Line Interface
4-94
Command Usage
If no interface is specified, information on all interfaces is displayed.
Example
This example shows the configuration setting for port 2.
* Not supported in the present version
* Not supported in the current version
Console#show interfaces switchport ethernet 1/2
Information of Eth 1/2
Broadcast threshold: Enabled, 650 packets/second
Lacp status: Disabled
Ingress rate limit: disable,100M bits per second
Egress rate limit: disable,100M bits per second
VLAN membership mode: Hybrid
Ingress rule: Disabled
Acceptable frame type: All frames
Native VLAN: 1
Priority for untagged traffic: 0
Gvrp status: Disabled*
Allowed Vlan: 1(u),
Forbidden Vlan:
Console#
Field Description
Broadcast threshold Shows if broadcast storm suppression is enabled or disabled; if enabled it also
shows the threshold level (page 4-89).
Lacp status Shows if Link Aggregation Control Protocol has been enabled or disabled
(page 4-99).
Ingress/Egress rate limit Shows if rate limiting is enabled, and the current rate limit. (page 4-97).
VLAN membership mode Indicates membership mode as Trunk or Hybrid (page 4-140).
Ingress rule
Shows if ingress filtering is enabled or disabled (page 4-141).
Acceptable frame type Shows if acceptable VLAN frames include all types or tagged frames only
(page 4-140).
Native VLAN Indicates the default Port VLAN ID (page 4-142).
Priority for untagged traffic Indicates the default priority for untagged frames (page 4-147).
Allowed Vlan
Shows the VLANs this interface has joined, where “(u)” indicates untagged and
“(t)” indicates tagged (page 4-142).
Forbidden Vlan Shows the VLANs this interface cannot dynamically join via GVRP.*