Accton Technology VS4512DC - Manual (Page 19)

System Defaults
1-5
System Defaults
The switch’s system defaults are provided in the configuration file
“Factory_Default_Config.cfg.” To reset the switch defaults, this file should be set as
the startup configuration file (page 3-17).
The following table lists some of the basic system defaults.
Function Parameter Default
IP Settings Management VLAN 1
DHCP Enabled
BOOTP Disabled
User Specified Disabled
IP Address 0.0.0.0
Subnet Mask 255.0.0.0
Default Gateway 0.0.0.0
Console Port
Connection Baud Rate 9600
Data bits 8
Stop bits 1
Parity none
Local Console Timeout 0 (disabled)
Authentication Privileged Exec Level Username “admin”
Password “admin”
Normal Exec Level Username “guest”
Password “guest”
Enable Privileged Exec from
Normal Exec Level Password “super”
RADIUS Authentication Disabled
TACACS Authentication Disabled
802.1x Port Authentication Disabled
SSL Enabled
HTTPS Enabled
SSH version 2.0 Enabled
Port Security Disabled