Accton Technology VS4512DC - Manual (Page 47)

Basic Configuration
3-17
Setting the Startup Configuration File
If you download to a new file name, select the new file from the drop-down list for
Startup Configuration File, and press Apply Changes. To use the new settings,
reboot the system via the System/Reset menu.
CLI – Enter the IP address of the TFTP server, specify the source file on the server,
set the startup file name on the switch, and then restart the switch.
Copying the Running Configuration to a File
You can copy the running configuration to a file.
If you download the startup configuration file under a new file name, you can set this
file as the startup file at a later time, and then restart the switch.
Console#copy tftp startup-config 4-55
TFTP server ip address: 192.168.1.19
Source configuration file name: config-1
Startup configuration file name [] : startup
\Write to FLASH Programming.
-Write to FLASH finish.
Success.
Console#reload
Console#copy tftp startup-config 4-55
TFTP server ip address: 192.168.1.19
Source configuration file name: startup2.0
Startup configuration file name [startup] : startup2.0
/
Console#config
Console(config)#boot system config: startup-new
4-59
Console(config)#exit
Console#reload
4-20