Accton Technology VS4512DC - Manual (Page 129)

Class of Service Configuration
3-99
Command Attributes
• Default Priority* – The priority that is assigned to untagged frames received on
the specified interface. (Range: 0 - 7, Default: 0)
• Number of Egress Traffic Classes – The number of queue buffers provided for
each port.
* The CLI displays this information as “Priority for untagged traffic.”
Web – Click Priority, Default Port Priority or Default Trunk Priority. Modify the default
priority for any interface, then click Apply.
CLI – This example assigns a default priority of 5 to port 3.
* Not supported in the current version
Console(config)#interface ethernet 1/3 4-84
Console(config-if)#switchport priority default 5 4-147
Console(config-if)#end
Console#show interfaces switchport ethernet 1/5
4-93
Information of Eth 1/5
Broadcast threshold: Enabled, 500 packets/second
Lacp status: Disabled
Ingress rate limit: disable,100M bits per second
Egress rate limit: disable,100M bits per second
VLAN membership mode: Hybrid
Ingress rule: Disabled
Acceptable frame type: All frames
Native VLAN: 1
Priority for untagged traffic: 0
Gvrp status: Disabled*
Allowed Vlan: 1(u),
Forbidden Vlan:
Console#