Acme PP-32 - Manual (Page 92)

92
PP-32
KOOLMASTER PP-32
REV.01
Load Configuration
Press +/- to start
Save Configuration
Press +/- to start
8.2 Saving a Configuration
Saving a Configuration from the PP-32 Controller
into the Configuration Module:
1- Place the configuration module on the J1
connector, at the top left corner of the
board, with the components facing DOWN.
2- Simultaneously press the up and
down-arrow keys during
a 5 second delay. The following
message is displayed : “ Load
Configuration Press +/- to start”.
3 - Press the up-arrow key once. The
following message is displayed:
“Save Configuration Press +/- to
start”.
4- Simultaneously press the +and - push buttons . The
configuration starts to save. Wait until it is completely saved.
5- Once the configuration has reached 100%, press the up and down-
arrow keys once again to exit this menu.
6- The new configuration is now saved on the configuration module.
Remove the configuration module from the connector.