Acme PP-32 - Manual (Page 68)

68
PP-32
KOOLMASTER PP-32
REV.01
Select "2.Inlet Sensors" then press
the right-arrow key. This option is
only available in the installer mode
(see sec. 5.14.2).
Use the navigation buttons to select
the desired inlet then press the right-
arrow key . Sensors that have been
activated during the installation are
displayed (see sec. 5.14.3).
Use the right and left-arrow keys to
select the desired sensor. When the
item is flashing, press
to
activate the sensor or to
deactivate it.
Proceed in similar fashion to assign sensors to each air inlet in use.
5.14.4.4 Assigning Sensors to Auxiliary Outputs
Auxiliary outputs use the average temperature of their assigned sensors
to operate. This parameter is common to all programs and can only be
set in the installer mode (see sec. 5.14.2). Select sensors that are used
for the operation of each auxiliary output as follows:
Set the function to "17.Fan Settings" from the main menu using
the navigation buttons. Note that this menu is only available in the
installer mode (see sec. 5.14.2).
Press the down-arrow key once to
select "2.Sensors" menu then press
the right-arrow key.
Use the navigation buttons to select
"2.Auxiliary 1" or "3.Auxiliary 2"
menu. Sensors that have been
activated during the installation are
displayed (see sec. 5.14.3).
Inlet 1 Sensors
1234567
√ √
Inlet Settings
1. Inlet Comp
2. Inlet Sensors
Inlet Sensors
1. Inlet 1
2. Inlet 2
Ventilation Stage
Settings
2. Sensors
Sensor Settings
2. Auxiliary 1
3. Auxiliary 2