NORD Drivesystems BU0135 User Manual
Page 73
5 Parameterisation
BU 0135 GB-2713
Pre-series version
73
Parameter
{ Factory setting }
Setting value / Description / Note
READ
RAM
READ /
FLASH
FLASH
P709
[-01]
...
[-04]
Potentiomet. status
(Potentiometer status)
x
0.0 ... 100.0 %
Displays the measured analog input value at the potentiometers.
[-01] =
Potentiometer 1
[-02] =
Potentiometer 2
[-03] =
Potentiometer 3
[-04] =
Potentiometer 4
P711
Digital output status
(Status of digital output)
x
0000 ... 0111
(bin)
or
00 ... 07
(hex)
Indicates the actual status of the digital outputs of the motor starter.
Bit 0 = Digital output 1
Bit 1 = Digital output 2
Bit 2 = mechanical brake
Bits 3-0
Minimum value
0000
0
Binary
hex
Maximum value
0111
7
Binary
hex
SimpleBox: The binary Bits are converted into a hexadecimal value and displayed.
ParameterBox: The Bits are displayed with increasing values from right to left (binary).
P716
Actual frequency
(Actual frequency)
x
-70.0 ... 70.0 Hz
Displays the actual output frequency. This is calculated from the mains frequency and the
selected direction of rotation on enabling. "0" is output when the device is switched off.
P718
Mains frequency
(Mains frequency)
x
-70.0 ... 70.0 Hz
Displays the mains frequency determined by the motor starter.
P719
Actual current
(Actual current)
x
0.0 ... 999.9 A
Displays the actual output current.
P720
Effective current
(Actual effective current)
x
-999.9 ... 999.9 A
Displays the actually measured effective current.
à negative values = generator, à positive values = drive
P721
Reactive current
(Actual reactive current)
x
-999.9 ... 999.9 A
Displays the actually measured reactive current.
P722
Current voltage
(Actual voltage)
x
0 ... 500 V
Displays the actual AC voltage supplied by the motor starter output.
P723
Voltage -d
(Actual voltage component Ud)
S
0 ... 500 V
Usually this value is "0"