NORD Drivesystems BU0135 - Manual (Page 45)

4 Commissioning
BU 0135 GB-2713 Pre-series version 45
4.2.2 Configuration
Most cases can be catered for directly via the functions of potentiometers P1 ... P4 as well as DIP switch
S1. For extended functions or for diagnostic purposes it may be necessary to adjust or view individual
parameters.
The use of a ParameterBox (SK CSX-3H / SK PAR) or NORD CON software is necessary to change the
parameters. The most important parameters are listed below:
Parameter group Parameter numbers Functions Comments
Motor data P203 Rated current of motor Usually value from P1
P210 Start phase section for
devices with soft start
Usually the value from P3
Basic parameters P102 … P103 Acceleration and deceleration
time for
devices with soft start
Usually the value from P4
P108 Switch-off mode for
devices with soft start
Usually the value from S1
P130 Parameter source Potentiometer / DIP switch or
parameter
Control terminals P420, P434 Digital inputs and outputs Usually a fixed function
Additional parameters P570 Locking time for reverse starting Usually the value from P2
Information P700 Present error