NORD Drivesystems BU0135 - Manual (Page 41)

3 Display and control
BU 0135 GB-2713 Pre-series version 41
3 Display and control
By the use of various modules for display, control and parameterisation, the SK 1x5E can be easily adapted
to various requirements.
No additional control units are required for simple commissioning. Alpha-numeric displays and control
modules can be used for the adaptation of individual parameters. For more complex tasks, connection to a
PC system and the use of NORD CON parameterisation software is available. The cover of the device must
be removed in order to access the diagnostic interface.
As supplied, without additional options, the diagnostic LEDs are externally visible. These signal the actual
device status. 4 potentiometers and 4 DIP switches are provided in order to set the most important
parameters. Of these, two potentiometers can also be accessed with the housing cover closed via the
diagnostic connection.
Potentiometer P3
Potentiometer P2
Diagnostic connection
PROFIBUS address
LED for AS interface
Potentiometer P1
Status LED DS
Diagnostic interface
Potentiometer P4