NORD Drivesystems BU0135 - Manual (Page 33)

2 Assembly and installation
BU 0135 GB-2713 Pre-series version 33
Installation
Mounting of a plug connector on the housing of the motor starter is usually only possible with a connection
adapter (connection extension SK TIE4-HAN10E).
Plug connector* Part. No. Technical data plus
SK TIE4-HAN10E
(275274100)
HAN 10E LA 2BUE
(Power output)
275135010 Add-on housing with 2-clamp lock, socket insert 10-pin. +
PE, spring terminals, PE: Screw connection,
electrical data: 16A 500V
X
HAN 10E LE 1BUE
(Power input)
275135070 Add-on housing with 1-clamp lock, pin insert 10-pin. +
PE, spring terminals, PE: Screw connection,
electrical data: 16A 500V
X
HAN 10E LE 2BUE
(Power input)
275135000 Add-on housing with 2-clamp lock, pin insert 10-pin. +
PE, spring terminals, PE: Screw connection,
electrical data: 16A 500V
X
HAN 10E MA 2BUE
(Motor output)
275135020 Add-on housing with 2-clamp lock, socket insert 10-pin. +
PE, spring terminals, PE: Screw connection,
electrical data: 16A 500V
X
HQ8 LA
(Power output)
275135040 Add-on housing, socket insert 8-pin. + PE, crimp connec-
tion,
electrical data: 16A 500V
X
HQ8 LE
(Power input)
275135030 Add-on housing, pin insert 8-pin. + PE, crimp connection,
electrical data: 16A 500V
X
HQ8 MA
(Motor output)
275135050 Add-on housing, socket insert 8-pin. + PE, crimp connec-
tion,
electrical data: 16A 500V
X
Connection extension
HAN Q5
(Power input + motor
or power output)
275274110 2 x add-on housing on a connector frame, each with one
5-pin pin insert + PE and a 5-pin socket insert + PE,
crimp connection, PE: Screw connection,
electrical data: 16A, 230V/400V
Not required!
* Further types available on request
The connection extension SK TIE4-HAN10E contains all the additional elements required for the HAN 10E
and HAN Q8 versions listed above. Installation is recommended as follows. Steps 2 and 3 are not required
for plug version HAN Q5.
Step 1 Step 2 Step 3 Step 4 Step 5
Disassembly of the
2 x M25 blank plug
Put on seal Put on adapter plate Install the add-on
plug housing with
screws and contact
washers Make the electrical
connections
2.7.2 Plug connectors for control connection
Various M12 round plug connectors are available as flanged plugs or flanged sockets. The plug connectors
are intended for installation in the housing box and can be oriented as required. The protection class (IP67)
of the plug connector only applies in the screwed state. The cover caps correspond to the colour version as
does the plastic body of the plug connector.