FUTEK IHH500 Series - Manual (Page 90)

EM1001-B
- 90 -
10 Thomas, Irvine, CA 92618 USA
Tel: (949) 465-0900
Fax: (949) 465-0905
Toll Free: (800) 23 FUTEK
6.5 Interfaces
Interfaces
ASCII Output
Relay1 Output
Relay2 Output
Voltage Output
Current Output
Power Output
USB Output
Bridge Input
Voltage Input
Current Input
The following can be either enabled or disabled under the Interfaces menu:
USB output, ASCII output, Relay 1 output, Relay 2 output, Voltage output, Current output, Power
output, Bridge input, Voltage input, and Current input. A check mark next to the item indicates that item
has been activated.
Output enable: This feature enables a 24 V/1W power supply to be used as an excitation voltage
(power supply) for an amplified sensor which requires an external power supply. It is highly
recommended to disable this feature when a bridge type sensor is connected to the IHH500.
Using this feature will enable the internal DC-DC converter, thus providing high voltage. It should
be noted that the battery discharges faster when working with amplified sensors.
OUTPUT CONFIG
► INTERFACES
LCD SETTING
LOCK SETTING