FUTEK IHH500 Series - Manual (Page 19)

EM1001-B
- 19 -
10 Thomas, Irvine, CA 92618 USA
Tel: (949) 465-0900
Fax: (949) 465-0905
Toll Free: (800) 23 FUTEK
The shunt key can be pressed any time after the device has been calibrated and a new sensor profile has
been loaded. The simulated value is to be used as a calibration reference. SHUNT will blink on the
display when enabled.
When both SHUNT and HOLD are active on the last row, the display will switch between blinking
SHUNT and blinking HOLD.
+3.03461 Peak
+3.03460 mV/V
+1.59484 Valley
01 Gross SHUNT