KYORITSU 6305 Instruction Manual - Manual (Page 8)

7
KEW6305
CAUTION
● Caution should be taken since conductors under test may be hot.
● Never apply currents or voltages exceeding the maximum allowable input for the instrument for a
long time.
● Do not apply currents or voltages for the Voltage test leads or Clamp sensors while the instrument
is off.
● Don’t use the instrument at dusty places or to be spattered.
● Don’t use the instrument under a strong electric storm or in the vicinity of energized object.
● Never give strong vibrations or drop shocks.
● While using a SD card, do not replace or remove the card. (
symbol blinks while accessing
SD card.)
Otherwise, the saved data in the card may be lost or the instrument may be damaged.
- Clamp sensor -
● Do not bend or pull the cable of the Clamp sensor.
- Treatment after use -
● Power off the instrument and disconnect the Power cord, Voltage test leads and Clamp sensors
from the
instrument.
● Remove the batteries if the instrument is to be stored and will not be in use for a long period.
● Remove the SD card when carrying the instrument.
● Never give strong vibrations or drop shocks when carrying the instrument.
● Do not expose the instrument to direct sunlight, high temperatures, humidity or dew.
● Use a damp cloth with neutral detergent or water for cleaning the instrument. Do not use
abrasives or solvents.
● Do not store the instrument if it is wet.
Carefully read and follow the instructions: DANGER,
WARNING
, CAUTION and
NOTE ( )
described in each section.
The following symbols are used in this manual:
User must refer to the explanations in the instruction manual.
Instrument with double or reinforced insulation
AC
(Functional) Earth terminal
～