KYORITSU 6305 Instruction Manual User Manual
Page 75
KEW6305
6.10
● Customizing
1
Press the
ENTER
key either on Screen 1 or 2, to enter into custom display mode.
2
Parameter displayed in upper row {eg. initial value: Screen1/ V(Voltage), Screen 2/P(Active power) } will
flicker.
3
Select the row to be customized using the
UP or DOWN cursor
key and the parameter to be selected with
LEFT or RIGHT cursor
key.
4
When customizing other rows, select the row and parameters in same way.
5
Select any parameter you want to display it at each row, and press the
ENTER
key.
Selecting row
Screen 1
1
Screen 2
Selecting parameters
NOTE
* “f” can be customized only at the upper row, and “In” can be displayed only at the middle row. (when wiring
configuration is three-phase 4-wire)
* On pressing the
ENTER
key whilst on Screen 3, the instrument will display Screen 1-A custom mode.
* Customizing cannot be done during an integration/ demand measurement whilst a survey is underway. This
applies also for integration/demand stand by mode.
* After system reset, start-up screen appears.
* Pressing the
ESC
key during custom display mode restores the original displayed parameters.
V
A
P
PF
S
Q
f
（
In）
Screen 1 Middle
Screen 1 Upper
Screen 1 Lower
Screen 2 Middle
Screen 1 Upper
Screen 2 Lower