KYORITSU 6305 Instruction Manual - Manual (Page 116)

9.3 KEW6305
9.2 Placing / removing SD card
△ DANGER
● Do not open the SD card Cover during a measurement.
△ WARNING
● Ensure that Voltage test leads and Clamp sensors are removed from the
instrument, and that the Function switch is set at the “OFF” position when
placing/ removing SD card.
△ CAUTION
● Ensure that the Function switch is set at the “OFF” position when placing/
removing SD card. Otherwise, the stored data may be lost or the
instrument may be damaged.
● Inserting SD card:
(1) Loosen the screw for SD card cover, and open the SD card cover.
(2) Insert an SD card into SD card slot with the topside turned up.
(3) Then close the cover and tighten up the screw.
● Removing SD card:
(1) Loosen the screw for SD card cover, and open the SD card cover.
(2) Gently push the SD card towards inside, and then the card comes out. Remove the card slowly.
(3) Close the cover and tighten up the screw.
Function switch: OFF
SD Card connector cover
SD Card
SD Card Connector