KROHNE IFC 110 Converter - Manual (Page 27)

Part B IFC 110 F Signal converter Sect. 3
05/2003 IFC 110 F 27
Setting data: Here you can note down the settings of the signal converter !
Fct. No.
Function Settings
1.01 Full-scale range
1.02 Time constant
1.03 Low-flow cut-off ON: OFF:
1.04 Display Flow
Totalizer
Messages
Trend
1.05 Current output I Function
Reverse range
Range I
Error
1.06 Pulse output P Function
Pulswidth
Pulse value
1.07 Pulse output A1 or
Status output A1
(for setting see below, Fct. 3.07,
terminal A1)
1.08 Status output A2
1.09 Status output A3
1.10 Status output A4
1.11 Control input C1
1.12 Control input C2
3.01 Language
3.02 Flow sensor Meter size
GK value
Field frequency
Power frequency
Flow direction
3.04 Entry code required ? no yes
→ → → ↵ ↵ ↵ ↑ ↑ ↑
3.05 User-defined unit
3.06 Application Flow is steady
pulsating
Empty Pipe no
Detection (EPD) yes
3.07 Hardware-settings Terminal A1 is Pulse output
or Status output
3.08 Measuring point
3.09 Communication of
HART or
KROHNE RS 485
Address:
Baud rate: