KROHNE CORIMASS G-MFM 4085 EN - Manual (Page 39)

39
Fct. No. Text Description and settings
3.8.0 USER DATA Submenu 3.8.0 User data
3.8.1 LANGUAGE Language for display text
* GB/USA (= English)
* F (= French)
* D (= German)
3.8.2 ENTRY.CODE1 Entry code for accessing menus required?
* NO (Entry to menus with the
→
key only)
* YES(Entry with
→
key and 9-keystroke code see
Fct 3.8.3)
3.8.3 CODE 1 Set Code 1 (Fct. 3.8.2 must be set to YES otherwise this
function is not available)
* Factory setting:
→ → → ↵ ↵ ↵ ↑ ↑ ↑
* If a different code is required:
press any 9-keystroke combination and then press the
same key combination again. Each keystroke is
acknowledged by "*". CODE WRONG (incorrect entry)
appears if 1st and 2nd entries are not the same. Press
↵
then
→
keys and repeat the procedure.
3.8.4 LOCATION Tag name setting (measuring point number)
Required only for flow meters using the MIC 500 Hand
Held Communicator (HHC), connected to current output)..
Factory setting: ”MFC 085”
Characters assignable to each place:
A...Z / 0...9 / + / - / * / = / // ( > = blank character)
3.8.5 ENABL. RESET Allow totaliser reset from the RESET/ACKNOWLEDGE
menu or with Control.Input E
Select : NO/YES
3.8.6 CSTDY CODE 3 Custody transfer required?
The function is protected by the CODE E password. After
pressing the
→
key enter a 9-keystroke password. If in-
correct, 9 characters are displayed which can be decoded
in the factory, otherwise select:
* NO
(No protection)
* YES (Custody Transfer Protection required)
3.8.7 CODE 3 CodE E setting (9 characters). (If custody transfer
is active then this function is unavailable)
* Factory setting:
↵ → ↑ ↵ ↑ → ↵ → ↑
* If a different code is required, press any 9-keystroke
combination and then press the same key combination
again. Each keystroke is acknowledged by "*".
CODE WRONG appears if 1st and 2nd entries are not the
same. Press
↵
then
→
keys and repeat the procedure.
3.8.8 PARAM.CODE 4 Extra code
↵ ↑
to allow subsequent access to
Menus: Fct. 3.1.5
Fct. 3.1.6
Fct. 3.9.3
Fct. 3.9.4