KROHNE CORIMASS G-MFM 4085 EN - Manual (Page 34)

34
Fct. No. Text Description and settings
3.2.0 DISPLAY Submenu 3.2.0 DISPLAY
3.2.1 CYCL. DISP. Cyclic display required?
Setting NO or YES. If YES is selected then in
measurement mode the display will switch from Mass
Flow to Density to Total to Temperature every 4 seconds.
3.2.2 STATUS MSG. Which status messages to be displayed ?
* NO MESSAGE (= no warning messages in main
display, warning system ignores status of outputs)
* PRIMRY.HEAD (= light warning messages in the
main display, warning system ignores status of
outputs)
* OUTPUT (= output saturation/alarm status
messages in the main display)
* ALL MSG. (= all warning messages in the main
display. System responds to output status)
3.2.3 MASS FLOW Units and format for mass flow display
* g, kg, t, oz, lb per s, min, h, d
* Number of digits after the decimal point selectable.
3.2.4 MASS TOTAL Units and format for totaliser
* g, kg, t, oz, lb
* Number of digits after the decimal point selectable.
3.2.5 DENSITY Units and format for density
* g, kg, t, per cm3, dm3, litre, m3 or
oz, lb per in3 ,ft3 , USgal, gallon or SG (Specific
Gravity relative to water at 20
°
C)
* Number of digits after the decimal point selectable.
3.2.6 TEMPERAT. Units for temperature
* °C or °F
* Format fixed at 1 decimal place
3.2.7 VOLUME.FLOW Units and format for volume flow
* Select OFF (no volume flow display) or
* cm3, dm3, litre, m3 , in3 ,ft3 , USgal, or gallon
per
* s, min, hr, day
* Number of digits after the decimal point selectable.
3.2.8 VOL.TOTAL Units and format for totalizer
cm
3
, dm
3
, liter, m
3
, inch
3
, ft
3
, US gal, gallon.
3.2.9 to 3.2.11 Concentration menu when installed.
Please refer to separate Concentration instruction manual